Timber Flooring Bondi | Apartment Flooring, Sanding & Polishing

The interwar apartment blocks that define much of Bondi carry floor-covering by-laws, concrete slabs and — in the older buildings — minimal acoustic separation beyond the slab itself. As in Cremorne, that puts the entire acoustic burden on the underlay system, and makes honest expectation-setting about lab ratings versus installed performance important.

The terraces and semis behind the beach carry original boards worth restoring, with the same gap-filling and movement considerations as Woollahra.

And then there is the coast. Higher humidity, sharper seasonal swing, and sand tracked in year-round. Sand is abrasive; it will wear a coating faster here than inland. The practical answers are a harder-wearing finish, a recoat before the wear reaches the timber, and engineered rather than solid where the humidity swing is doing the most work.

What we are usually called for in Bondi

Deco apartment acoustics
Terrace floor restoration
Coastal wear and recoating

More about the Eastern Suburbs

Services available in Bondi

Timber flooring installation

Engineered oak, solid hardwood, hybrid and vinyl plank — measured, moisture-tested, acclimatised and installed to the manufacturer’s specification.

Floor sanding & polishing

Bringing tired, dark, scratched floorboards back to raw timber and finishing them properly — with dust extraction that keeps the rest of the house liveable.

Engineered oak flooring

The most specified floor in Sydney right now, and for good reason — real timber wear layer, far more dimensional stability than solid, and it suits apartments.

Hybrid, SPC & vinyl plank

Waterproof, hard-wearing and quieter underfoot than laminate — the sensible answer for wet areas, rentals, holiday houses and anywhere with kids and dogs.

Repairs & restoration

Water damage, squeaks, cupped boards, gaps and holes where a wall used to be — repaired and blended so the fix does not become the thing you look at.

Subfloor preparation

The least visible part of the job and the part that decides whether the floor above it lasts. Always assessed on site, always quoted separately.

Flooring in Bondi: common questions

How often should a floor near the beach be recoated?

More often than an inland floor, because sand tracked in from the beach is abrasive and wears the coating faster. The rule is to recoat before the finish wears through to bare timber — once the timber itself is exposed and marked, a full sand is required instead, which is far more expensive and uses up wear layer. A light buff and recoat every few years in high-traffic areas is much cheaper.

Timber flooring in Bondi